1. Welcome,
    SXSNation is a UTV Community that brings enthusiasts together regardless of brand, a place to find local rides, partake in discussion, buy or sell within a marketplace, or just rant about anything side by sides. Interact directly with top Vendors in the Industry, find exclusive discounts and specials and participate in weekly giveaways! If you haven't registered yet, what are you waiting for?
    Dismiss Notice

Keyed power issue

Discussion in 'Ranger Nation' started by Nighthawk, Jan 18, 2020.

Users Viewing Thread (Users: 0, Guests: 0)

  1. Nighthawk

    Nighthawk Keith SXS Nation Rookie

    Joined:
    Jan 18, 2020
    Posts:
    10
    Likes Received:
    1
    Location:
    Tipp city ohio
    Side X Side(s):

    2019 Polaris 1000 ranger

    I am new here, I have a new Polaris ranger 1000. A couple weeks ago I installed a 18 light bar above front brush bar. Powered by pulse bar wired to yellow and black pin (top and middle connector. Last week I installed a 50 inch curve light bar plugging into pulse bar on roof. Last night I tried tiring in two cube lights on 50 inch light bar which harness had open plug to add to harness. Got it tied in and then lost power. I do not have keyed power center pin with key on. I do have constant power on bottom pin. I checked relays in fuse box and fuses. All good. Accesory fuse on pulse bars good. Does anyone know how keyed power comes to pulse bars. I lost keyed power to both pulse bars. Thanks in advance
     

Share This Page