1. Welcome,
    SXSNation is a UTV Community that brings enthusiasts together regardless of brand, a place to find local rides, partake in discussion, buy or sell within a marketplace, or just rant about anything side by sides. Interact directly with top Vendors in the Industry, find exclusive discounts and specials and participate in weekly giveaways! If you haven't registered yet, what are you waiting for?
    Dismiss Notice

Sixity Axles

Discussion in 'Teryx Nation' started by Teerex15, Aug 10, 2019.

Users Viewing Thread (Users: 0, Guests: 0)

  1. Teerex15

    Teerex15 Rob SXS Nation Rookie

    Joined:
    May 10, 2019
    Posts:
    5
    Likes Received:
    0
    Location:
    PA
    Side X Side(s):

    Teryx 4 LE

    Just a note, If your running Sixity axles with a 2” Brute Performance lift, the outer joint will rub on your A-arms when the suspension is at its longest point. It’s worse if you are running A-arm guards too because that’s where the attachment point is. The outer joint has a larger diameter than stock. There’s only about an 1/8” clearance at static.
     

    Attached Files:

  2. Rockin Ronnie

    Rockin Ronnie Ron Moderator

    Joined:
    May 20, 2017
    Posts:
    728
    Likes Received:
    472
    Location:
    Evart, Michigan
    Side X Side(s):

    17 Polaris General
    13 Polaris Ranger

    I don't see anyplace that is rubbing in your pic's. the 1/8 clearance would be good with no warn parts the axle will not move other then the axle flex in the joint then just the boot would be flexing .
     

Share This Page